• No predrilling! Faster and easier than through bolts.
• Approved for single sided installation. Unlike nails and other screws of similar diameter that need to be installed from both sides.
• Higher side load capacity with fewer fasteners saves time and labor.
• Correct thread length for engineered lumber–No board jacking.
• Prevents gapping or cupping between plies which can occur in nailed applications.
• Winged point, modified thread design and anti-friction coating combine to significantly reduce installation torque.
• Specified by Trus Joist®, Boise®, GP® and other leading wood manufacturers.
• Free hex head driver bit.

Epoxy coated with anti-friction top coat. Corrosion resistant without risk of hydrogen embrittlement.

• Install using a 1/2" corded or 18 volt cordless drill.
• Bring underside of washer-head flush with wood surface. Do not countersink.
• Choose correct TrussLok length. See below.
• Always refer to engineered wood manufacturer’s literature for proper fastening pattern, design load information and additional fastener installation requirements.
• Contact FastenMaster at 800-518-3569 with any questions.
• Maintain a minimum distance of 2" from any edge and 4" from end of beam. Suggested TrussLok Application (TABLE GOES HERE) All fastening patterns and procedures must comply with building codes and engineered wood manufacturer’s requirements. Photographs showing the TrussLok usage should not be used as a reference for fastening patterns.