• Smooth finished look even in high density composites.
• Deep #1 square drive provides best bit engagement, reducing cam out. 
• Concave underside of head conceals loose material for a clean and beautiful finished appearance.
• Approved in ACQ and Copper Azole.
• Color coated to match composite deck boards.

TrapEase II is guaranteed not to rust or streak in composite decking for the life of the project when installed correctly. The fastener has also been tested and approved for fastening composite decking to ACQ and CA-B. Please use TrapEase Stainless Steel Composite Deck Screws when the application is within 1,000 feet of salt water or when de-icing salts will be in contact with decking.

• Use a 0-1800 RPM variable speed corded or 18V cordless non-impact drill. Install fastener in a continuous drive until head is slightly below flush.
• Install two screws at every joist.
• When fastening within 1 1/2" from the end of a board, follow the common practice of predrilling a pilot hole using a 1/8" bit. This will prevent the board from splitting.
• Install screws no closer thaan 3/4" from edge of board.
• Do not use TrapEase II when attaching composites over "fixed" surfaces: sleep systems, roof decks, solid wood surfaces (facia, handrails) or metal joists.
• TrapEase Stainless Steel screws are recommended in these fixed surface conditions or when decking is being applied over restricted airspace (less than 12" of clearance below the joists on 3 sides).
• For solid wood decking please use our GuardDog Exterior Wood Fastener.