Lateral Tension System for Decks

The Lateral Tension System (LTS) is a complete system designed to transfer the lateral forces on an exterior deck when attached to the wood frame of a structure.

Code Changes

The International Residential Code (IRC) requires that decks be designed to withstand both vertical and lateral loads.

This 2015 code allows for tension ties to be attached to the deck joist then fastened directly to an interior sill plate, wall plate or stud – all from the outside.

Installation Instructions

  • Installed in four locations along the length of the ledger
  • One within 2' of each end of the ledger with two more evenly spaced between.
  • Install the fastener first and then add the bracket.
  • No need to access the interior the house.
  • Designed to resist 750 pounds in tension per location.

The Lateral Tension System is approved for the five most common installation conditions:

  • Condition A: Sill Plate or Wall Plate Behind Ledger
  • Condition B: Sill Plate or Wall Plate Directly Below Ledger
  • Condition C: Sill Plate or Wall Plate 2” – 5” below Ledger
  • Condition D: Wall Stud in line with Deck Joist
  • Condition E: Wall Stud between Deck Joists

One Complete Kit

The FastenMaster LTS, is one complete kit to make all four of these code conforming connections. Each LTS bracket attaches an individual deck joist to a structural framing member of the house.

For the Lateral Tension System technical bulletin, download it here.

For technical documentation of all our structural wood screws, see our Technical Resources page.